IR routing table equals

(Slink-e 2.0 and above only)

Response Code:

Binary: [1 0 0 1 1 1 1 1] [0 0 0 0 1 0 1 0] [IRRX0 routelist] [IRRX0 carrier] ... [IRRX7 routelist] [IRRX7 carrier]


This response describes the IR routing table. The routelist byte for each IRRX port specifies which IRTX ports the received signal will be echoed to. The format for this byte is the same as the Set IR transmit ports command. The carrier byte specifes the carrier frequency to be used in the routed signals from a given IRRX port. This byte is equivalent to the CC byte in the Set IR carrier command. To reduce data storage requirements, no prescaler value can be specified and the prescaler is defaulted to 0 instead. This means that 15.7khz is the lowest available carrier frequency for IR routing.