Binary: [p2 p1 p0 1 1 1 1 1] [1 0 0 0 0 0 0 1]
Description:
This is an error message. The Slink-e began to transmit your message to the port but didn’t receive all of the data from you in time to make a continuous transmission. Solution: send port send commands temporally closer together in your software. This can also be due to using too low of a baud rate for IR transmissions. Always use 19.2kbps or 38.4kbps for IR. This is considered a critical error and causes the Slink-e to enter the resume state.